Quiet Electronics Moderated Newsgroup For The Electronic Professionals and Other Professionals > Arkansas
> Used
> Turret tool post fits unimat lathe,taig, sherline,7X12
Turret tool post fits unimat lathe,taig, sherline,7X12
This is a Brand New turret tool post custom made to fit the unimat db 200 & sl 1000 lathe. Just bolt it on the cross slide, install your tools and you are good to go.
This is a quality, AMERICAN BUILT product and features the following:
* 24 position indexing with detents (indexes every 15 degrees)
* 2" Square Turret Block holds (4) 1/4" tool bits. (Tool slot size is 5/16")
* ADAPTABLE to fit any lathe. (.472" (12 MM) minimum vertical distance required from the centerline of headstock to the top of the compound or cross slide) (May require a spacer block under the tool post if used on lathes with a different vertical center distance.)
* Smooth and positive operation. The turret block is positively raised up and off the detents while turning the handle and locks down solidly-there are no springs to fail.
* Saves set up time on the lathe.
