Quiet Electronics Moderated Newsgroup For The Electronic Professionals and Other Professionals   >   Kentucky   >   Used   >   Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working

Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working


Hurco CNC knee mill. Full 3 axis, 5 inches Z cnc travel, apx 15 inches Z knee travel. 24" X travel, 14" Y travel. Mid 1980's model.
Is equiped with a kwikswitch nmbt 30 taper tool holder. Comes with 30 toolholders, including a floating tap holder, boring head, and over 60 pcs. of ER-16 collapsable collets. 60-4000 rpm head 2 speed. 250 ipm. rapids.
Has a seperate coolant pump and tank. 1\2 horse power coolant motor. Turns on from the controller. Has a tape emulator. Seperate computer to store and save programs. Has helix, and ellipse, package. I have a spare servo motor, pump parts, and everything needed to rebuild the head, (900$) worth. The head runs fine but has a little noise when you turn it off. Hence the rebuild parts. Has a working, centralized auto lube system. Working air brake on the spindle.
What I was told when I bought this was that it had recently been rebuilt, put back into service and then the company decided to upgrade all of its machines. It has not seen much use since then. Just look at the pictures of the ways, they look like new!!!
Has Programming and wireing manuals.
It is set up for use with single phase power.
MY RESERVE IS SET VERY LOW, LESS THAN THE COST OF THE TOOLING ALONE!!!!
Due to age of machine no warrenty expresesd or implied.
My reserve is set at only 2900$



Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working Hurco cnc mill, KMB1-m, kwikswitch,toolholders, working