Quiet Electronics Moderated Newsgroup For The Electronic Professionals and Other Professionals > Iowa
> Used
> Machining of metal~textbook~smith, ph.d.~©1949~old~rare
Machining of metal~textbook~smith, ph.d.~©1949~old~rare
MACHINE SHOP~REVISED EDITION~©1949
1 - hardback: Machining of Metal~Textbook~by Robert E. Smith, Ph.D.~©1949. From the Introduction: Experiences gained in the school shop through work in the machining of metal are worthwhile because: (1) they help one to understand & appreciate how the machinist, the toolmaker, & the machine operator serve society; (2) through these experiences one is able to discover ability & a liking for, or lack of ability & a dislike for, this sort of work as a possible vocation; (3) the skills & work habits acquired are applicable & usable in many industries & under many & varying conditions….
Publisher: McKnight & McKnight Publishing Co.; Bloomington, IL.
Date Published & Copyright Date: Revised Edition, ©1949.
Description: This hardback textbook is in good condition. The front & back covers show some wear—see the scan of the front cover. The yellow tape over the spine was used to write the book number. The pages are clean, except for an occasional grease smudge. The edges of the pages are slightly soiled. This textbook was never issued to a student, but appears to have been used.
Binding: In very good condition—no separation.
Did you use this textbook when you were in school? This vintage, rare, & collectible 59-year-old textbook has 10 sections in 224 pages. There are many descriptive diagrams, photos, & charts. In a cursory look, I did not notice any writing or underlining in the book. This textbook measures about: 7-7/8" x 10-1/2".
- Measurements & Measuring Instruments
- The Tool Grinder & Its Operation
- The Milling Machine & Its Operation
- The Power Hack Saw & Its Operation
- Metal Cutting Band Saws & Their Operation
- Surface Grinding Machines & Grinding
I obtained this textbook from a retired high school shop teacher. I am not a metalworker, book collector, or dealer, but I have tried to honestly describe this very useful textbook.
$1.65 ................ $0.01 to $50
$2.05 ................ $50.01 to $100
$2.45 ................ $100.01 to $200
1 - hardback Machining of Metal~Textbook~by Robert E. Smith, Ph.D.~1949.
